評価: 13
2
I have in the works a new 3D printed rear display housing as i was an idiot and threw away the broken old one, however i don't want this new part breaking due to tight hinges, and being an almost 30 year old notebook the grease in the hinges as all but dried up, I'm looking for some assistance or an experts opinion on the verdict.
評価: 783.4千
1.1千
893
2.3千
@ltdavis003 no expert, not brain surgeon, just an old dude who likes to mess with stuff. You could try and remove as much of the old gunk as you can. Then clean with some isopropyl alcohol and/or WD40. It's a decent creep oil and cleans out most of the gunk. Try to move the hinges a bit of a time while you clean it. Hopefully it will loosen the decade old gunk and free the mechanism as much as possible.
On my old iron, I prefer to lubricate hinges etc. with some silicon grease. You can find this even as a spray lubricant and it is tolerated well by the older plastic cases.
このアンサーは役に立ちましたか？
過去 24時間: 0
過去 7 日: 0
過去 30 日: 1
今までの合計 26
