My series 500 washes spins drains then instead of going to complete or done it starts sensing and filling with water again. It will run forever unless you unplug it. If you plug it back in it will automatically start a wash cycle again. I have ran the calibration several times.
評価: 450.6千
11
367
1.4千
Here's the Tech sheet for the washer that may help.
Run the diagnostics as shown on p.2 and check if any error codes are displayed.
There's a table on the bottom right of p.3 that shows how to interpret the status LEDs to know what the code is.
The fault error code and description are shown on p.6-p.7.
Hopefully a start in finding out what's happening.
このアンサーは役に立ちましたか？
過去 24時間: 1
過去 7 日: 13
過去 30 日: 90
今までの合計 344
Hi @scottmason18891,
What is the model number of the washer?
jayeff さんによる
Model 11025102310 Kenmore series 500.
Scott Mason さんによる