修理を始めるには コミュニティ ストア

廉価版で携帯バージョン、統合されたJoy-Conコントローラと若干縮小したスクリーンを持つNintendo Switchハードウェアです。2019年9月20日発売。

178回答 すべてを表示

オプション

Replacing Right Shoulder Button

Hello!

I was performing a stick swap to fix a drifting joystick on my switch lite. During that, the exposed rubber for R button ripped off when removing the plastic bumper. I've only ever soldered a couple things, and I'm having issus getting the solder to melt. I've got new buttons, but the repairs I see are all for joycons and they don't seem to have issues with the solder not melting.

Has anyone performed this kind of repair or have any advice to get this button swapped out?

A photo of the broken button is attached.

Any help is greatly, greatly, appreciated.

Thanks!

Block Image

回答がありました！ 回答を表示 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 0
コメントを追加

1 件の回答

フィルタ：
参考になった順 新しい順 古い順
ベストアンサー

オプション

What solder are you using? Use 60/40 leaded. Also what soldering iron are you using? Add a pic if you can. Also use flux. It helps with the transfer of heat allowing the solder to melt.

このアンサーは役に立ちましたか？

はい いいえ
スコア 0

2 件のコメント:

Thanks for the reply! I had my soldering iron set too low. I originally found 260° C was a good temperature, but after looking again I saw 360° C was recommended. I changed my iron to 360° C and I was able to melt the solder and get the button off. I had an issue with the through holes, but since they were only there as supports, I was able to remove (tear) the button portion from the support mounts. After that I resoldered a new button the the data pins and supports mounts and everything has been working great for about a week now. If anyone else needs to do this, make sure you resolder the button as close to the board as you can. The space to fit the shoulder button is very tight.

さんによる

Hello, for the replacement part? Does a joy con part works as well? (The bumper R solder part)

さんによる

コメントを追加

回答を追加する

Brandon Paul さん、ありがとうございました！
統計データ:

過去 24時間: 2

過去 7 日: 12

過去 30 日: 57

今までの合計 860