I recently bought the $30 Kit that came with a Tripoint Y1000. It helped get the main 4 screws on the back, but not the middle ones as it was too small. So I ordered the one referenced in the guide (Y1) and it was too big. Why would they advertise a screwdriver that is incapable of getting the job done? I just need to know now if it's a Y10 or a Y100 that I need, because I am getting impatient.
評価: 1.6千
17
4
8
A Y0 + firm pressure works fine for me. Your screws might be tighter than normal or a bit stripped, in which case you can use a piece of fabric between the screw and screwdriver. Just make sure your bit doesn't slip between the threads, and don't rush it.
このアンサーは役に立ちましたか？
I didn't think of the fabric part, I may try that. TY
評価: 685.3千
3.4千
1.1千
2.6千
過去 24時間: 0
過去 7 日: 0
過去 30 日: 5
今までの合計 96
