Is it the power supply? Lit LED, 1 none else.

Question

iMac G5 20" Model A1145

2.1 GHz G5 processor

77回答すべてを表示

philaro @philaro

評価: 21

2

投稿日: 2012年1月27日

オプション

Is it the power supply? Lit LED, 1 none else.

LED stays lit when I plug my iMac G5 in, but when I push the power button, LED 2 flickers on for less than a second and then goes off again. The iMac stays black.

I have tried to reset the SMU by plugging it in while holding the power button, but nothing has changed.

The computer became bricked after a brief power outage (and was the only machine in the house not on a power strip).

mayer wrote responding to "Where is a decoder for diagnostic LED pattern"

LED 1 indicates that trickle voltage from the power supply has been detected. This LED will be ON when the computer is turned off and your power supply is working correctly.

LED 2 indicates that the main logic board has detected proper power

回答がありました！ 回答を表示同じ問題があります

この質問は役に立ちましたか？

はいいいえ

スコア -1

コメントを追加

2件の回答

ベストアンサー

mayer @mayer

評価: 685.4千

MacHale Enterprises

3.4千

1.1千

2.6千

投稿日: 2012年1月28日

オプション

Replace your power supply.

このアンサーは役に立ちましたか？

はいいいえ

スコア 5

3 件のコメント:

Thanks. I'll order one and see how it goes!

philaro さんによる2012年1月29日

Well it was the power supply - I'm using the computer to write this follow up. It didn't take hours to fix either - it took half an hour.

I discovered that you may not need to do more than get the front bezel off and lift up the display to swap out the power unit - the hidden connector that otherwise takes hours of disassembly to get at pulls out with a bit of firm-but-gentle sideways wiggling.

My step 18 note "If you are changing the power supply - this is a good point to remove the screws to the old power supply to see if the connectors (both of them) are accessible. If you can gently (but firmly) pull the two-wire connector out from under the chassis, you can install the new unit at this step ...

Live on iMac G5, live on!

philaro さんによる2012年2月7日

Glad I could help you solve your problem ;-)

mayer さんによる2012年2月8日

コメントを追加

Well it was the power supply - I'm using the computer to write this follow up. It didn't take hours to fix either - it took half an hour.

I discovered that you may not need to do more than get the front bezel off and lift up the display to swap out the power unit - the hidden connector that otherwise takes hours of disassembly to get at pulls out with a bit of firm-but-gentle sideways wiggling.

My step 18 note "If you are changing the power supply - this is a good point to remove the screws to the old power supply to see if the connectors (both of them) are accessible. If you can gently (but firmly) pull the two-wire connector out from under the chassis, you can install the new unit at this step ...

Live on iMac G5, live on! — philaro

Jimmyn86 @jimmyn86 評価: 1 · Answer 1 · 2013-02-01T00:35:27-07:00

Jimmyn86 @jimmyn86

評価: 1

投稿日: 2013年2月1日

オプション

I have the same problem only 1 led light up.I have an imac 27 "intel. might be power supply?

このアンサーは役に立ちましたか？

はいいいえ

スコア 0

コメントを追加

iMac G5 20" Model A1145

Is it the power supply? Lit LED, 1 none else.

2件の回答

回答を追加する