Ipad3g dead, was crushed

Question

iPad 3Gモデル

Appleの初代iPadで、3G無線接続に対応しているモデルです。モデル番号はA1337。ストレージ容量は16, 32,もしくは64GBから選べます。修理は簡単で、熱で温めて接着剤を柔らかくする作業が要りません。

72回答すべてを表示

JCM @jcm67999

評価: 37

4

1

投稿日: 2012年1月8日

オプション

Ipad3g dead, was crushed

I received an iPad3g that was ran over. While the display and touch panel were broken, the internal parts did not look bad. I cleaned it up and put it back together. The display shoes white light so I ordered a new display and touch pad. I put it all together doublecheching all connections but now it is dead. While it was apart I tested the battery pack and it tested good. Prior to taking it apart I had put the new screen and noticed that the battery was almost dead as the display worked but when I attempted to charge the unit overnight it did not charge. Also, it did not get detected by my laptop and I tunes diagnostics could not communicate with it. Does anyone have any schematics with testing points I can use to diagnose? Note I disassembled this device down to the shell in order to reform the warped shell.

Thanks

回答がありました！ 回答を表示同じ問題があります

この質問は役に立ちましたか？

はいいいえ

スコア 3

コメントを追加

2件の回答

ベストアンサー

oldturkey03 @oldturkey03

評価: 784.3千

1.1千

894

2.3千

投稿日: 2012年1月8日

オプション

JCM, schematics for any Apple device are a very rare commodity. It sounds to me like all of your errors are leading to the dock connector. I would start with that one and work from there.

JCM, good luck with your repair. I hope it will work out for you. The same diagram is available at pinout.ru and has some more information as well ;-)

このアンサーは役に立ちましたか？

はいいいえ

スコア 3

4 件のコメント:

Thanks oldturkey03. I found out there is a storefront near me and it is listed as being an authorized Apple repair shop. Il see if I catch them on Monday and see if they can guide me so wish me luck..I actually found pin-outs for the connector on some music site where a guy customizes an IPad, here is the blog link which can come handy. http://gfgsm.blogspot.com/2011/02/apple-...

JCM さんによる2012年1月10日

Some of those pinouts will be useful and I also found some more,thanks. I went to the Apple authorized repair place and it was a joke. They said that IPads are not repairable just swappable through Apple. I thought that a few years ago the FTC or commerce dept had created a law that stated certain consumer products needed to be supported by the manufacturer but I could be wrong. I pulled the pins off one of the connectors yesterday taking it apart again :( so now I have a liitle more to work on soldering tiny pins. The dock cable is a little costly to purchase so I may just have to put the project on the side if I can't figure the wiring for troubleshooting. I'll see if some else gives me another broken one and swap parts out to narrow down the problem.

JCM さんによる2012年1月17日

Sounds reasonable, let us know how it is going :-) best of luck to you.

oldturkey03 さんによる2012年1月17日

If you decide it's not worth a fix, I found a student that is looking for a BAD logic board for a school project ... for the right price you could get it off your hands and help a young fellow geek out...

Any Body know where I can get a broken iPad Logic Board?

Country Computer Service さんによる2012年1月18日

コメントを追加

Thanks oldturkey03. I found out there is a storefront near me and it is listed as being an authorized Apple repair shop. Il see if I catch them on Monday and see if they can guide me so wish me luck..I actually found pin-outs for the connector on some music site where a guy customizes an IPad, here is the blog link which can come handy. http://gfgsm.blogspot.com/2011/02/apple-... — JCM
Some of those pinouts will be useful and I also found some more,thanks. I went to the Apple authorized repair place and it was a joke. They said that IPads are not repairable just swappable through Apple. I thought that a few years ago the FTC or commerce dept had created a law that stated certain consumer products needed to be supported by the manufacturer but I could be wrong. I pulled the pins off one of the connectors yesterday taking it apart again :( so now I have a liitle more to work on soldering tiny pins. The dock cable is a little costly to purchase so I may just have to put the project on the side if I can't figure the wiring for troubleshooting. I'll see if some else gives me another broken one and swap parts out to narrow down the problem. — JCM
Sounds reasonable, let us know how it is going :-) best of luck to you. — oldturkey03
If you decide it's not worth a fix, I found a student that is looking for a BAD logic board for a school project ... for the right price you could get it off your hands and help a young fellow geek out...

Any Body know where I can get a broken iPad Logic Board? — Country Computer Service

kerri @kerri64459 評価: 329 6 2 1 · Answer 1 · 2014-02-04T19:18:42-07:00

kerri @kerri64459

評価: 329

6

2

1

投稿日: 2014年2月4日

オプション

Ou after all that it's sounds like u need a new charge port a super easy repair!

このアンサーは役に立ちましたか？

はいいいえ

スコア 0

コメントを追加

iPad 3Gモデル

Ipad3g dead, was crushed

2件の回答

Update

回答を追加する