評価: 23
1
Hi, so I was triyng to replace my HDMI port and I ended up blowing some resistors I think? off my board I was wondering if anyone knows what they are ( values ) and where I can get some replacements.
この質問は役に立ちましたか？
評価: 1.3千
4
1
from just last night. I always tape the surrounding area off. This time, I also put a little bit of tape in the lane between the anchors. It makes rendering the pads on the other side molten a bit trickier, which means having to keep the heat on it a bit longer, which mean causing the tape to "fail." However, it did preserve both the SMDs and their directionality.
I also always take a picture of the before as reference (2nd pic of 2nd link; marked up with the answer to your question). DJ Diodes are commonly used in PS4 display issue repairs. I don't know how to go about ordering the ones marked up in yellow, but I did provide the reading that I got on mine (SAF-003).
I just noticed another diode like the ones marked in yellow above the large, A1 diode. You can take readings from that off your own board to confirm.
このアンサーは役に立ちましたか？
@dushku any objections to pulling your images to your answer?
@oldturkey03 If by pulling, you mean removing from this post, I would object. If you mean pulling as in copying to use elsewhere, go right ahead!
@dushku as in making them visible on here instead having rto link to an outside site.
@oldturkey03 Sure. Is that the preferred way of doing it here? If so, I'll try and do that next time.
@dushku that way your images will always be connected to your answer/question whatever it maybe. If you post them somewhere else, and that site goes down etc., important information could be lost. BTW great answers on those consoles. Hope you are going to revive some of the Xboxes as well ;-)
過去 24時間: 1
過去 7 日: 3
過去 30 日: 12
今までの合計 280
