修理を始めるには コミュニティ ストア

Repair guides and support for all-in-one washer and dryer assemblies as well as stacked units.

139回答 すべてを表示

オプション

Kenmore washer combo stuck in end cycle

I have a kenmore washer and gas dryer combo that's stuck in the end cycle. My wife put some clothes in the washer, accidentally started it on casual, turned the knob to normal, and pressed it again. The lid locked and then it just went into the end cycle where it drains and does a light spin.

I haven't been able to get it to stop. I press the knob and it just beeps 2 fast beeps and then one solo beep right after. The lid stays locked as well. I've unplugged it overnight and that didn't work. I checked the circuit board and nothing is out of place.

What could be causing this and how the heck do I fix it?

この質問に回答する 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 0
2 件のコメント

Hi,

What is the model number of the combo unit?

さんによる

The number inside of the dryer door is 417-71722510. I still can't get the lid for the washer to unlock. I checked the pump for obstructions and everything. I'm at a loss.

さんによる

コメントを追加

1 件の回答

フィルタ：
参考になった順 新しい順 古い順
最も参考になった回答

オプション

Hi,

The 2:1 (E21?) beep error code you mentioned doesn't seem to be listed in the service manual for the model series. Not sure if this will work but try getting into the diagnostic mode and clear all the error codes, by pressing and hold the cycle selector knob for 5 seconds and then running the diagnostics again and see what you get

このアンサーは役に立ちましたか？

はい いいえ
スコア 1

1件のコメント:

I pulled the water pump to test the rotor and it will only turn a quarter turn before it stops and bounces back. It appears that the pump is most likely the culprit. The downside is, sears stopped carrying the part in their parts direct warehouse. I had to scoure the internet for a replacement. The part might be in tomorrow or Saturday. Time will tell if this is actually the solution.

さんによる

コメントを追加

回答を追加する

mashashin さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 7

今までの合計 159