I have a similar problem with our MVWB65FW3 commercial washer. I start the washer, light on Sensing turns on and drum spins very slowly 2-3 cycles before it goes to Wash cycle but immediately stops and returns to sensing. Repeats this cycle 4-5 times before it finally turns off. Takes a while before Lid Lock releases.
評価: 453.7千
11
369
1.4千
Hi @smileynv
Here's the Tech sheet for the washer (assuming you meant MVWB765FW3?).
Run the diagnostics as described in the sheet and check what error codes are shown. The sheet shows the most likely causes for each error code.
Hopefully a start
このアンサーは役に立ちましたか？
過去 24時間: 2
過去 7 日: 2
過去 30 日: 12
今までの合計 44
2 件のコメント
Did you ever finf out how to fix your washer, im having the same problem. I havr the same model as yours
Sandra Gonzalo さんによる
@sandragonzalo
What does performing the diagnostic tests show, if anything? See the Most Helpful Answer below.
jayeff さんによる