修理を始めるには コミュニティ ストア

第8世代iPad、2020年9月18日発売、32GBモデルと128GBモデルがあります。モデル番号A2270。

17回答 すべてを表示

オプション

Pinout of Home Button Connector? iPad 8 Wifi, torn pads

I have a iPad 8 and some monster pulled a few pads off trying to replace home button zif connector. I started scraping to see if I can follow the traces. They are not clearly seen through the mask like I see some show.

Didn't want to start tearing all the mask off, and figure someone has seen this. Do we know where these traces go to ? Does it even use all the traces? iPad 8 seems to be the only ipad I don't have info on. Here is a pic of what I have under the microscope.

Block Image

Thanks in advance !

Update (08/20/2022)

Oh my bad, it's a A2270

この質問に回答する 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 3
1件のコメント

Oddly enough, the pads that lifted are not used. The half pads I was able to use and still connected. I believe I'm good, i'll assembly and test. Purchased ZXW to confirm pin location to componets.

さんによる

コメントを追加

1 件の回答

フィルタ：
参考になった順 新しい順 古い順
最も参考になった回答

オプション

Hi

If you get a multi metre and put it in continuity try this

Put one probe on ground and the other on the bit that you scraped the mask off and see if there is continuity to ground

The reason why I am ask for you to do this is because it looks like a ground pad because of its size,obviously it’s quite hard to say but I don’t see traces going under a connector very often

I would have a look for a schematic and Board view so you can see where the actually go

Hopefully this helps

Any questions please ask

Thanks:-)

このアンサーは役に立ちましたか？

はい いいえ
スコア 1

2 件のコメント:

Hi does anyone have the schematic for the iPad 8 for the above area as I lost what looks like a micro resistor

さんによる

The area is near the FPC connector on iPad 8 WiFi A2270 I lost a resistor but cannot see the value as they don’t seem to be written on

さんによる

コメントを追加

回答を追加する

Eric さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 4

過去 30 日: 11

今までの合計 439