Dryer runs, no errors. No heat, and no error codes.
Tested thermal fuse with a multi-meter, and it looks fine.
There is some slightly toasted lent at the bottom, but not a fire.
Are there guides for troubleshooting the gas solenoid or the igniter ?
Thank You
評価: 450.6千
11
367
1.4千
Figured it out.
There were enough spiderwebs inside, that it restricted fresh air flow.
So the flame from the burner was not pulling far enough down the draw tube to not land on the thermal sensor above the ignitor.
It was a fine layer of webs, so I just didn't notice them at first. But once wiped away, it works well once again.
Thanks for the help, sincerely !
このアンサーは役に立ちましたか？
過去 24時間: 0
過去 7 日: 0
過去 30 日: 3
今までの合計 137
2 件のコメント
Hi @garose ,
What is the model number of the dryer?
jayeff さんによる
The model number is 110.94821300
Type: DADT-NAT-1206006-EL22
Thank you
Garry さんによる