メインコンテンツにスキップ

Repair information for Whirlpool dishwashers.

157回答 すべてを表示

Dishwasher stops after few seconds

Hello,

My dishwasher stops a few seconds after starting. It did that for a while and initially opening then closing the door would help it continue. Later it needed more open/close for it to do the job. Now it won’t continue at all. When I open it I see water at the bottom. Pressing cancel will drain this out. There are no beeps and nothing on the display to show why it is stopping. Any ideas what to try? Model # wdt910ssym0

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 0
1件のコメント

Mon Nasser sounds like a bad door switch. Clean the door seal and the door opening make sure that there is no debris etc. Try to push the door a bit while you turn on your DW and keep holding it. See if that makes a difference.

さんによる

コメントを追加

1 件の回答

最も参考になった回答

Hi,

Here’s the tech sheet for the dishwasher.

Try running the diagnostic tests as described in the sheet and check what error codes are displayed to find out what’s wrong.

このアンサーは役に立ちましたか?

スコア 1
コメントを追加

回答を追加する

Mon Nasser さん、ありがとうございました!
統計データ:

過去 24時間: 1

過去 7 日: 12

過去 30 日: 56

今までの合計 2,125