メインコンテンツにスキップ

2013年9月10日に発表されたApple iPhone 5sの修理情報とガイドです。モデル A1533、A1453、A1457、A1528、A1530、A1518。

3530回答 すべてを表示

iPhone 5s battery replace issues

Hello i replaced my iphone 5s battery but when start my phone battery charge status 1% when i recharge battery its jump and stuck on 27% percent

After i shutdown my phone and on it Again battery comes on 1% again are there any solutions

Also my phone randomly rebooting after 2-3 minutes

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 0
1件のコメント

where did you get the battery from?

さんによる

コメントを追加

2件の回答

最も参考になった回答

So you make Battery BSI track open. See around the battery connector you can see some parts are missing. If the coil is missing simply jumper it and enjoy.

このアンサーは役に立ちましたか?

スコア 1

1件のコメント:

Please explain more i not understand what you are mean

さんによる

コメントを追加

The symptoms your iPhone have is most likely caused by a damage logic board. Take a good look at the logic board around where the battery connector is, it is possible that you have knock of a small component of the logic board when you have replaced the battery. You might need a magnifier or microscope to see it, at the place where component is missing you can make a jumper between the two pads. Sorry for my poor English but I hope you understand what I try to explaine.

see this for example: https://youtu.be/Q4fIp9vgsB8

このアンサーは役に立ちましたか?

スコア 0

2 件のコメント:

Hey

Unfortunately i not have  microscope but if there's any missing  part around  battery  socket are that component repairable?

And are you think maybe  the new  battery  have a problem  i am so scared  about component if they  missing

Sorry  for  my poor  English

さんによる

I think the problem is in a missing component around the battery connector, take a magnifier and take a look, it isn’t that difficult to make a jumper, I use silver conductive glue to make this jumper. Much easier then with micro solderen.

さんによる

コメントを追加

回答を追加する

Abdurrahman Najdi さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 4

今までの合計 74