メインコンテンツにスキップ

Repair guides and support for the first generation Nissan Murano, from the 2003 model year to 2007.

19回答 すべてを表示

when I pour water in my radiator it runs to mh crackcase drain plug

My problem is when i pour water in my radiator it runs to mh crackcase drain plug non stop flow.its been hydrolocked..still starts with a loid rattle noise…can anybody help

回答がありました! 回答を表示 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

2件の回答

ベストアンサー

Most probable is either a failed gasket or a cracked block. Water its heavier than oil, so it will go to the bottom of the drain pan.

このアンサーは役に立ちましたか?

スコア 1

1件のコメント:

Could it be a oil coolier line

さんによる

コメントを追加

That is a symptom not the problem. Sounds like a blown head gasket at best and at worst a cracked block or maybe a thrown rod that has resulted in a compromised engine water jacket. You could start with removing cylinder head(s) to see if the problem is obviously limited to a head gasket issue. Either way this will be a major expense to repair or replace the engine in all probability. Good luck sir.

このアンサーは役に立ちましたか?

スコア 0

2 件のコメント:

That is fast if its a blown head gasket it but could be a cracked block i hope..if i could fix it then i think it will come right.it still seems to run on all 8 cylinders jus a rattle and not much oil flowing to the top

さんによる

These vehicles come with either a v6 or an i4 engine only as manufactured. If it pours out the drain plug as fast as you pour it in, then the engine is likely unrepairable.

さんによる

コメントを追加

回答を追加する

leon poipoi さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 7

過去 30 日: 11

今までの合計 51