メインコンテンツにスキップ

iPhoneの第2世代モデル。モデル番号はA1241 / 8 もしくは16 GBの容量/ ブラックもしくはホワイトのプラスチック製背面ケース。修理はオリジナルiPhoneに比べて直接パーツに作業ができます。ドライバー、こじ開けるためのツールと吸盤カップが必要です。

1158回答 すべてを表示

empty battery with thunderbolt on screen

Hi

Just encountered a problem. I disassambeled my iphone to change the housing, then when i put in back together it worked fine, but it stoped charging, which I noticed this morning when I found my phone pluged to the wall with an empty battery and a thunderbolt on its screen...

So the question is might it be the broken wire of the dock connector? Im not sure because itunes still finds the phone in dfu mode and I even tried to restore it but it didnt work...

回答がありました! 回答を表示 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

1 件の回答

ベストアンサー

If the dock connection cable is loose or damaged your home button won't work either. If this is the case then all you will need to do is replace the dock connector and you should be good to go. You can also check to see if the connection has been made properly. If your home button is still working (press it and see if the screen turns on) then continue reading.

When you replaced the back assembly there is a possibility that the battery feet were not correctly seated and therefore are not receiving any charge. Try taking out the logic board and making sure the battery feet are correctly in place and have the screw holder in the middle.

Below are two images of the correct and incorrect placement of the battery feet.

Wrong

Block Image

Right

Block Image

Hope this helps! :)

このアンサーは役に立ちましたか?

スコア 4

2 件のコメント:

Thank u it worked!=)

But the only thing i had to do is to loose the screws on the mother board (since i didnt take out the battary) and it started charging immediately!

Sorry it took me so long to get to ur post...

anyway thx again!)

さんによる

No worries! I'm very glad I can help!

さんによる

コメントを追加

回答を追加する

Sith さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 1,335