Repair guides and troubleshooting for the Wizard RT550, a rotary tool made by Black & Decker.
Vince DeLuca @vjdeluca
評価: 1
投稿日: 2019年8月2日
After tightening an accessory into place with the collett nut, it doesn’t grip enough, so tool such a saw just stops when pressed against object.
この質問は役に立ちましたか?
tcagle53 @professorc
評価: 8.2千
Professor C's E-repair and Upgrade Service
24
12
8
投稿日: 2019年8月3日
Measure the shaft on the tool in question. It is probably 3/32” and you probably have a 1/8” collet installed in the collet nut. If you have lost that part or did not get it with the tool they are readily available on line.
https://www.ereplacementparts.com/collet...
このアンサーは役に立ちましたか?
過去 24時間: 0
過去 7 日: 1
過去 30 日: 11
今までの合計 350