解決済み: Spin Cycle Needs Manual Attention - Kenmore Washer

Spin Cycle Needs Manual Attention

My top loaded Kenmore washer (Model 110) won’t spin on the spin cycle unless I open the door at the start of the spin cycle. It sounds like it’s spinning, but nothing happens until I lift the lid (which stops the motor), and then re-close the door (which then starts the spinning). I have no issues with the agitator, and I’ve replaced the lid switch but that didn’t fix the problem.

Since the spin function works when I re-close the door, I have a hard time thinking it’s the coupler or pressure switch.

Any ideas???

回答がありました！ 回答を表示同じ問題があります

この質問は役に立ちましたか？

はいいいえ

スコア 0

投稿日: 2019年6月13日

オプション

I suspect your neutral drain assembly of the transmission is not disengaging during the pause between the drain and spin cycles. When you open the lid and stop the engine, it removes enough pressure to allow the neutral drain assembly to disengage.

You may want to make sure the timer is allowing a long enough pause between the drain and spin cycles to give the motor enough time to coast to a stop and disengage the neutral drain. It should be about 2 minutes.

Also, here is a video replacing the neutral drain assembly: https://www.youtube.com/watch?v=cUOH67Wi...

このアンサーは役に立ちましたか？

はいいいえ

スコア 1

1件のコメント:

Thank you @tdunc15 ! Is it possible to change the amount of time between the drain and spin cycles?

Kenny Coleman さんによる2019年6月14日

コメントを追加

Kenmore Washing Machine

Spin Cycle Needs Manual Attention

1 件の回答

回答を追加する