Connect data wires of USB cord to phone

No I meant pins from where battery are connect (back side of phone )

Ok. It’s still unclear what you want to do. I’ll make it simple...

Your charger port is broken on the logic board,correct? If so,you must replace the port or connect the wires directly to the board. I can take pictures of an example if you’d like... I’d like to help you

When you say charging port,you do mean the part the usb cable plugs into,right?

Yes I meant "the part the USB cables plugs into "by charging port ...and unfortunately it is broken and I don't have tools for opening and soldering it ...so I thought if it is possible to connect those USB data wires into " phone battery connectors " (those 3 or 4 golden pins we can see after removing a 'removable' battery ) .......

I thought of this method because I have seen people flashing dead phones by connecting something in those battery connectors ) thank you for replying and for your kindness

No problem.

I honestly don’t know how that would even work. It doesn’t make sense to me. Charging the battery that way may not work correctly either. The reason there are more than 2 pins on the battery,is for the phone to read temperature of the battery,which allows it to tell if it’s overheating and slow down the charging current. Sometimes the 4th is for ground(in case of a surge). This is what I’ve heard. But the data pins for the battery shouldn’t have anything to do with the data in the phone.

Now,is the charging port not working,or did it pop off?

Where did you hear of people using the battery pin connectors like this? Maybe they were using them to charge the battery if the phone wasn’t charging it,but maybe the micro usb data pins worked??? So maybe they directly wired the power cables to the logic board battery pins?

I stay up late(5:40am here now). I will reply again if I see you responded.