Why is my power board burning?

Question

Vizio E420-A0

Vizio 42" LED TV released in September 2012.

45回答すべてを表示

Carey @tardisgrooves

評価: 25

2

投稿日: 2018年11月26日

オプション

Why is my power board burning?

I’ve had my Vizio model M471i-a2 for about 4 years, and about a week ago it started emitting a strong burning smell, and then the top of the screen started having Black flickerings. Took off the back and saw a substantial burn mark on the power board.

Ordered a new board and put the new one in Saturday. Now (Monday night) the same thing is happening all over again to the brand new board!

Here’s a picture of the other side

Thank you turkey! Here’s a pic of the whole side of that board in case that’s helpful:

この質問に回答する同じ問題があります

この質問は役に立ちましたか？

はいいいえ

スコア 2

5 件のコメント

Did you try connecting power through a different outlet?

TechTalks さんによる2018年11月26日

Yes I did try another outlet

Carey さんによる2018年11月27日

I have the same problem, did anyone find a solution for this?

Dude Linger さんによる2019年7月4日

Hey dude, it did end up being my LED backlights. I wish I would have known that before purchasing new boards, as it will just burn through any new board you install.

Carey さんによる2019年7月5日

I have this same issue on the same model tv. Same burn marks on same board. Do I need to replace the backlights and the board or just the backlights?

James Griffin さんによる2021年4月7日

コメントを追加

3件の回答

I have the same problem, did anyone find a solution for this? — Dude Linger
Hey dude, it did end up being my LED backlights. I wish I would have known that before purchasing new boards, as it will just burn through any new board you install. — Carey
I have this same issue on the same model tv. Same burn marks on same board. Do I need to replace the backlights and the board or just the backlights? — James Griffin

oldturkey03 @oldturkey03 評価: 781.5千 1.1千 893 2.3千 · Answer 1 · 2018-11-26T20:40:46-07:00

最も参考になった回答

oldturkey03 @oldturkey03

評価: 781.5千

1.1千

893

2.3千

投稿日: 2018年11月26日

オプション

@tardisgrooves

that is the cold side of the board and we really would need the underside of it as well. We would need to figure out what circuit those jumpers belong to. From their location I would think that this might be an issue related to the LED backlights. You can always try another board but do not connect the backlight connector and see if it does the same thing. without a schematic it could be difficult to check it any other way.

このアンサーは役に立ちましたか？

はいいいえ

スコア 3

3 件のコメント:

New pic below

Carey さんによる2018年11月27日

@tardisgrooves those look like MOSFETS Most likely for the LED boost circuit. I will try and see if I can find a schematic to verify this.

oldturkey03 さんによる2018年11月27日

Thank you turkey! Bigger pic below

Carey さんによる2018年11月28日

コメントを追加