評価: 1
1
I'm removing the display from the iMac g5's case and using it as a standalone monitor. However, I can't figure out what voltage is being supplied to the inverter from the 6-pin connector on the logic board. Any ideas or pinouts?
この質問は役に立ちましたか？
評価: 26.3千
152
71
50
From the PDF: To start L! inverter one needs 3,3V Run on the fi L n°2 the brown one is connected to the 12V Run and the fi L 3 is connected to the GRD the fi L n°1 (not connected) rule the luminosity and is with 0V.
The PDF is in French you can use Babel Fish or your favorite interpreter for the information you are seeking.
このアンサーは役に立ちましたか？
評価: 685.3千
3.4千
1.1千
2.6千
This answer might be able to help you: Display power inverter pinout or voltage for each of 6 pins needed?
このアンサーは役に立ちましたか？
AB you might want to make this clearer and enter it as an answer. My answer is just a link. Your answer has a lot more info than mine.
過去 24時間: 0
過去 7 日: 2
過去 30 日: 3
今までの合計 1,161
