メインコンテンツにスキップ

Repair and support for the third generation of the Flip portable speaker by JBL.

50の回答 すべて表示

Little part fell off the JBL flip 3 motherboard labeled 1R5

I dropped my JBL flip 3 speaker the other day and I started to hear a rattle inside so I decided to take it apart and see what it was and it was a small box at the top Corner of the motherboard labeled 1R5 and i don't know how to put it back on

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 2

コメント:

Exact same problem has happened to me, does anyone have a solution

による

the same excact thing happened to me

による

コメントを追加

MacBook Battery 修理キット

最低価格 $69.99

Buy Now

MacBook Battery 修理キット

最低価格 $69.99

Buy Now

3回答

@mtz13 without actually seeing what is going on, it is difficult to answer. Consider posting some picture of your board with your question. Use this guide iFixitでの質問に画像を追加する方法 for that. The 1R5 sounds like a fixed 1.5uH inductor. Again without seeing it, this is only an assumption. Those are usually soldered to the board and there is not other way reattach it.

この回答は役に立ちましたか?

スコア 0
コメントを追加

Something similar happened to me. The 1R5 piece didn't break down fully and now one contact is lose. I think the only way is to solder it down. https://imgur.com/a/2y4Xy

この回答は役に立ちましたか?

スコア 0
コメントを追加

I had the same problem and solved it by cutting a wine cork in size to press the 1R5 piece against the contact. Good luck

この回答は役に立ちましたか?

スコア 0
コメントを追加

回答を追加する

Joe さん、ありがとうございました!
統計データを表示:

過去 24時間: 0

過去 7 日: 3

過去 30 日: 29

今までの合計 953