評価: 13
1
I had it calibrated twice now and it now will not spin out all water. Then states sucking out water while lid is open . It would never even work without lid being lock before this. Please help
この質問は役に立ちましたか？
評価: 685.3千
3.4千
1.1千
2.6千
Start here:
Cause 1
Lid Switch Assembly
The lid switch assembly prevents the washer from spinning when the lid is open. If the lid switch assembly fails, the washer may stop mid-cycle. To determine if the lid switch assembly is defective, use a multimeter to test each of the lid switches for continuity. If a lid switch does not have continuity, replace it.
このアンサーは役に立ちましたか？
I unplugged my washer for an hour, and then plugged it back in and in ran it's cycles normal again... Idk why it was necessary but it reset it somehow,..good luck...
このアンサーは役に立ちましたか？
過去 24時間: 1
過去 7 日: 4
過去 30 日: 14
今までの合計 748
1件のコメント
I unplugged my washer for about 1 hour, and plugged it back in, and it went through it's cycles normal again..
Gwynne k Robertson さんによる