my tv comes up with a no signal message when i turn it on, i have to to do a total reset to get it to work, all is then fine until i turn it off, then have to to do it all over again next time i turn it on
この質問は役に立ちましたか？
評価: 101.2千
8
173
358
@paulineholt, Pauline, If you have setup your TV as per your TV's manual, perhaps some how the TV is set to Demo/shop/store mode, if in this mode will not retain your set up. See links below for instruction on removing demo/store mode. Good luck. I hope this helped you out, if so let me know by pressing the helpful button.
このアンサーは役に立ちましたか？
過去 24時間: 1
過去 7 日: 5
過去 30 日: 6
今までの合計 133
1件のコメント
@paulineholt how do you perform the total reset? How long has this been going on and has the TV ever fully functioned? Has anything happened that may have caused this?
oldturkey03 さんによる