メインコンテンツにスキップ

The Shark Rocket HV301 is the second installment of vacuums in the 300 series. It is a two-in-one vacuum that comes with several attachments, making it capable of cleaning on different surfaces. Its sleek and lightweight design make it easy to maneuver around any household.

17の回答 すべてを表示

Brush Roll Not Turning On

The brush roll will not turn on at all anymore. There seems to be no power getting to it. If I take the stick part off and attach it directly to the canister, it works. Do I need to buy a new stick? Where can I get one?

回答がありました! View the answer 同じ問題があります

この質問は役に立ちましたか?

スコア 4

コメント:

The Underestimated seems to be right in my case, although, the female connection (on the motor part of mine, rather than the stick) that is the problem, is not cluttered with debris. Rather, it seems to be missing the connection piece altogether. The hole is just empty. Ugh…what to do now…

by

I hve this problem and shark are not interested. So stick shark dyson has better aftersales

by

I have a rocket hv380 it dosent have a belt on this model but rollers not turning can't work it out any suggestions please

by

コメントを追加

Android 修理キット

交換用スクリーンやバッテリーの修理キット

ショップを見る

Android 修理キット

交換用スクリーンやバッテリーの修理キット

ショップを見る

4件の回答

選択されたソリューション

Hi,

It may be that the brush roll drive belt is broken.

Here is a link to the ifixit guide to repair / replace the brush roll. The belt is shown clearly in Step 8 of the guide.

If it is broken then here is a link to suppliers of the part.

Hopefully this is of some help.

この回答は役に立ちましたか?

スコア 3
コメントを追加

you have a loose wire in the extension handle part.

uplug the vacuum.

open up the handle and repair the torn / broken wire.

be sure to cover with electrical tape.

この回答は役に立ちましたか?

スコア 1

コメント:

Thanks for the answer except it is hard to know where on the handle it should be opened up. Pictures would be nice, but if not at least a good description of exactly where to open up. Thanks!

by

コメントを追加

You probably won't need a replacement part. I would start by checking the connections on the female side of the wand. I believe you will find that one more of the connections will have foriegn matter covering the contact points causing the problem. Please make sure your vacuum is unplugged from the power source before you clean the connections. Your welcome!

この回答は役に立ちましたか?

スコア 1

コメント:

This was exactly my issue- I had to use a needle to clear out the gunk (after unplugging of course!) and after a few minutes I could see a clean connection again. Worked like a charm. Thanks!

by

コメントを追加

I had the same and I contacted shark and they sent a replacement foot part free of charge.

この回答は役に立ちましたか?

スコア 0

コメント:

Did you have to show them your reciept? I've lost mine and can't use the warranty due to that.

by

コメントを追加

回答を追加する

Carrie Pandya さん、ありがとうございました!
統計データを表示:

Past 24 Hours: 21

Past 7 Days: 148

Past 30 Days: 593

今までの合計 19,300