修理を始めるには コミュニティ ストア

オプション

How to remove a grimy screw from PSone controller?

Trying to disassemble a PSone controller but stuck on one last screw near the top of the pad, behind the L1 and L2 buttons. My question is simply, how can I go about removing the final screw without stripping it? I've already had a difficult time removing the other screws due to excessive ammounts of grime on and in the controller.

Note:

1) The controller is old

2) It is caked with hand grime

3) It's gross

4) I want it apart so I can clean the darned thing

5) Did I mention that it's gross?

回答がありました！ 回答を表示 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 0
コメントを追加

2件の回答

フィルタ：
参考になった順 新しい順 古い順
ベストアンサー

オプション

One thing you could try is to get a q-tip and get some alcohol on it and try and soak that screw for a few minutes then use the other end of the q-tip to try and soak up the grime then try to take the screw out. That would be my suggestion.

このアンサーは役に立ちましたか？

はい いいえ
スコア 2

1件のコメント:

Thank you so much, this helped a lot!

さんによる

コメントを追加

オプション

Use a tiny bit of WD40 or similar and let it soak in, and then with a reasonable amount of pressure try turning the screw, only aim to turn it a little at a time, if it keeps "camming out" you might be using an unsuitable driver. Using one of the other screws you already have try and find a driver that as closely fits it as possible.

If in the end you do strip the head, you can always drill it out, not ideal, but it does get the job done.

このアンサーは役に立ちましたか？

はい いいえ
スコア 0

2 件のコメント:

Will keep this in mind for future reference. Considered using WD-40 but only as a last resort; it can be messy. Thank you as well!

さんによる

Yeah, WD40 can be messy but it's very effective against stuck screws.

Let me know how you get on.

さんによる

コメントを追加

回答を追加する

chelcee さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 3

過去 30 日: 19

今までの合計 290