メインコンテンツにスキップ

ユニボディMacBook Pro 13インチ Unibodyディスプレイモデルは2009年〜2012年に製造販売されました。

4630回答 すべてを表示

Clone Hardisk to SSD with Mac OS X & Bootcamp Windows 8 inside

can i clone old hardisk with new SSD with mac OS X & Bootcamp Windows 8 inside without lossing any data?

if can, what application i should use?

last question out of topic: does MBPro 2012 have M.2 slot on it?

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 0
3 件のコメント

Are you sure you have an older non-retina model here? Or do you have a retina model.

さんによる

Non Retina Display

さんによる

Then you'll use a standard 2.5" SATA drive.

さんによる

コメントを追加

1 件の回答

最も参考になった回答

No, you can't clone the drive for many different reasons.

You'll want to use the tools Apple provides to prep and install a fresh OS on your new drive so it is correctly configured. Once the OS is installed the last step asks if you want to migrate your data from an old drive, system or TimeMachine backup. This is when you'll move your stuff over and if you have Windows setup under BootCamp it will be transferred. Otherwise you'll need to use MS Windows backup & recovery tools if you are running Windows alone. You'll need a carrier to hold your original drive. OWC offers a USB3 case to hold the custom Apple SSD unit if you have a retina MacBook. If you have a older non-retina model then a SATA to USB adapter will be needed.

As for the type of drive interface your system has it is similar to the M.2 interface but its not compatible. Apple uses its own custom SSD units for their retina series systems. The older models use a standard 2.5" SATA drive.

このアンサーは役に立ちましたか?

スコア 1

2 件のコメント:

thank you for the answer, it's helpfully

さんによる

As you have a non-retina system you'll need to be careful on what drive you put in as the older models SATA port is only SATA II (3.0 Gb/s). You'll need to make sure the drives spec sheet states it runs at this slower speed. Review your systems specs here: EveryMac - Lookup Plug in your systems S/N and that will give you the specs for your system.

Last issue here: Apple had a problem with the HD SATA cable. You might want to visit an Apple Store or Apple authorized service center to have the cable replaced under the extended warranty problem Apple has for this if your current drive is having issues. Otherwise I would recommend replacing it when you replace the drive. Use the newer version of the cable found in the 2012 model.

さんによる

コメントを追加

回答を追加する

Ant1Hero さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 777