I rear ended someone a couple weeks ago and i got a new hood for my 1990 honda accord but my hood wont shut flush. I looked at my hood latch and it is bent inward, is there anyway i can fix it myself, if so, how?
評価: 101.2千
8
173
358
diego tamesis , If you are talking about the hood latch on top of rad support they can be bent out fairly easy. Tie a rope/chain/cable around the area of the latch/cradle and the other end wraps around a 2x4, put a rag between 2x4 and bumper, now use the 2x4 to pry the hood latch/cradle into correct position. May have to fine tune with a heavy hammer and board. Ifyou are not removing any thing such as radiator,A/C condenser,etc. take your time and be careful as you do not to damage other parts. See the link below, same idea, just not as drastic. Good luck.
I hope this helped you out, if so let me know by pressing the helpful button.
このアンサーは役に立ちましたか？
Thank you so much! appreciate it
diego tamesis, your welcome, I have actually had to do this before on a friends car. If you like the answer, accept it thanks.
Hi @lpfaff1 ,
Is a 'heavy hammer' also known as an American screwdriver where you are as well? ;-)
jayeff, :-))) I have not heard it termed that way, but maybe by some!
I had heard of that but the urban dictionary has: http://www.urbandictionary.com/define.ph...
過去 24時間: 1
過去 7 日: 4
過去 30 日: 12
今までの合計 1,152
