メインコンテンツにスキップ

AppleのiPad AirのWiFiモデルのバージョンはモデル番号A1474、スペースグレーと、シルバーがあり、カスタムA7プロセッサーが装備されており、容量は16、32、64、128GBがあります。

299回答 すべてを表示

Problems after iPad digitizer replacement - boot screen, home button

Hi folks,

Just replaced a crushed digitizer on an iPad Air gen1, hurray for new things learned. However, after I did the tear down and put it back together I seem to have a few issues:

1) when I turn on the ipad after the apple welcome logo, it goes black unless I hold down the power button to shut it off. That's when I get the slide to power off screen. After I cancel that I get the "click home button to unlock" but that's when I discover my second issue...

2) the home button on my new front panel replacement doesn't seem to work. I took it apart a second time and made sure that the slide connector and the latch are securely in place and I put that little black tape that was on the original back and still the same thing. At first it wast sticky so I thought I had just put it together wrong so I took it apart and made sure there wasn't anything gumming up the button travel.

Thoughts anyone?

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

1 件の回答

the new digitizer needs shielding. check jessa's post on her site iPad rehab where she talks about the iPad mini revealing it's secrets to her. you should get by with just shielding across the bottom of the digitizer on the inside, cover all the copper looking area. also if you check with the digitizer up not put down, I'm sure it behaves properly once booted up.

Update (01/26/2017)

could be a faulty home button, for sure a shielding thing with it working properly when up. are you sure that the home button was put in right? the gold part at the end of the home button flex needs to be facing up.

このアンサーは役に立ちましたか?

スコア 0

1件のコメント:

Hi Richard,

Thanks for responding. I also didn't clean out the old adhesive very well so it's easy to take the thing apart still... guess I might need a new adhesive set. It was behaving fine with the digitizer up, so something must be happening when I'm sealing it up, or perhaps I'm pinching the LCD cable when I seal it up.

Though the home button still doesn't work even when the digitizer is up. Could it be a faulty home button assembly? I don't think I mis-treated it...

Thoughts?

-Gary

さんによる

コメントを追加

回答を追加する

Gary Yee さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 5

過去 30 日: 6

今までの合計 73