修理を始めるには コミュニティ ストア

2014年9月19日に発売されました。この5.5インチサイズのスクリーンをもつiPhoneは、iPhone6の拡大サイズ版です。

1526回答 すべてを表示

オプション

Phone is stuck on a restart loop after after falling in water

Hi, last night I dropped my iPhone 6 Plus in hot water, I removed the iPhone from the water quickly, dried it with a towel, and it was fine. The first problem I encountered was that it said I had headphones in, but I fixed that with my headphones. My second problem was that my phone charged very slowly overnight, 23% in 6 hours. While getting on my bus, a message reading "Touch ID not accessible" appeared, and my Touch ID stopped working. I switched chargers when I got to school. After that everything seemed fine, I charged my phone when I got to school and it charged normally. Around 2 hours later, after my phone was done charging, my iPhone started the restart loop. I have attempted drying the case and removing it, drying and cleaning around the iPhone and case. What should I do???

回答がありました！ 回答を表示 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 0
コメントを追加

1 件の回答

フィルタ：
参考になった順 新しい順 古い順
ベストアンサー

オプション

You should have disassembled your phone and clean the internals BEFORE you did all this. Powering up a wet electronic device is never a good idea, now the internals are pretty screwed up and it is going to be a difficult repair.

Try to clean the board carefully using isopropyl alcohol, if any issue persists, this is beyond you, take the phone to a professional and don't expect it to come back fully functional without costing you a fortune.

このアンサーは役に立ちましたか？

はい いいえ
スコア 2

2 件のコメント:

Any further tips?? I've had my iPhone off since, and will follow through with the solution you suggested when I return him.

さんによる

By now the board must have been extensively corroded. Clean all the corrosion and see if it works, if not, board level repair is required.

さんによる

コメントを追加

回答を追加する

Tommy Waller さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 4

今までの合計 162