No video- not cable or connections.

Question

Nintendo 64

1996年6月23日に発売されたモデル番号NUS−001の64ビットゲームコンソールです。

114回答すべてを表示

Wombler @wombler

評価: 61

3

2

投稿日: 2010年9月6日

オプション

No video- not cable or connections.

So, not the common (cable) video issue with an NTSC version-

With all my games I have audio, but no video. The TV screen will go black when the unit is powered on and I get the audio from the game booting up. I know the cable is fine because it works on my buddy's Game Cube.

I've opened the unit up and used a point file (didn't have any isopropyl laying around at the time) on all the contacts- expansion pack, game slot, power connector and a/v connector. Also done the same with the contacts on the expansion pack and a few of the games.

just kinda wondering what my next steps are...

回答がありました！ 回答を表示同じ問題があります

この質問は役に立ちましたか？

はいいいえ

スコア 5

コメントを追加

4件の回答

ベストアンサー

BWest @bwest13850

評価: 3.3千

21

14

4

投稿日: 2010年9月10日

オプション

You can try a stepwise protocol, its worked for me in the past for reasons unknown. First, take everything out: controllers, game, and jumper/expansion pack. Power it on for about 10 seconds and turn off. Add the jumper/expansion and turn on for about 10 seconds. Then add the game and power on for 10 seconds, then try to actually play something. For some reason its worked for me in the past, but I had both video and audio issues. Worth a shot.

このアンサーは役に立ちましたか？

はいいいえ

スコア 5

5 件のコメント:

I was having the same problem... BWest you saved me!

Jason Mick さんによる2012年2月2日

This worked for me too. I had no signal whatsoever, performed these steps and it worked perfectly. Thank you so much BWest.

Neila Nuruodo さんによる2012年3月6日

I had the same issue and your solution fixed it. Amazing. Thanks

Brian Comer さんによる2012年3月16日

It sucks. It chucked it as hard as I could and it actually worked

Dakota sanford さんによる2018年3月25日

I had a unti that powered on but no video/audio. After removing jumper pack and running it for 10 seconds and reinserting it it worked but after turning off and on again the error came back.

It's a temporary solution and takes only few seconds but would still like to know what to do to permanently fix the issue.

Clément Meur (Chnorzy) さんによる2018年6月28日

コメントを追加

This worked for me too. I had no signal whatsoever, performed these steps and it worked perfectly. Thank you so much BWest. — Neila Nuruodo
I had the same issue and your solution fixed it. Amazing. Thanks — Brian Comer
It sucks. It chucked it as hard as I could and it actually worked — Dakota sanford
I had a unti that powered on but no video/audio. After removing jumper pack and running it for 10 seconds and reinserting it it worked but after turning off and on again the error came back.

It's a temporary solution and takes only few seconds but would still like to know what to do to permanently fix the issue. — Clément Meur (Chnorzy)