修理を始めるには コミュニティ ストア

2013年9月10日に発表されたApple iPhone 5cの修理情報とガイドです。モデル A1532, A1456

1233回答 すべてを表示
締切られた回答

オプション

Digitizer not responding after replacing with working screen/digitizer

Hi peeps,

I have received one iphone 5c which powers up, but doesn't respond when swiping to unlock.

I have another iphone 5c that has a working screen/digitizer, so I've taken this and replaced it with the non-responsive one. Same issue occurs - can't swipe to unlock.

Does anyone have any idea as to what could be causing this? Could it be a duff connector on the main board?

I'm pretty sure the phone may have been water damaged.

この質問に回答する 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 0

1件のコメント:

Anyone?... Anyone?... Bueller?

さんによる

コメントを追加

3件の回答

フィルタ：
参考になった順 新しい順 古い順

オプション

It is likely a board level issue, maybe a short or an issue with the U3. The digitizer connector would usually still allow the touchscreen to have limited responsiveness.

このアンサーは役に立ちましたか？

はい いいえ
スコア 0
コメントを追加

オプション

Dave C , this can be caused by a bad digitizer connector. As you can see the connector lacks metal ends and this is what makes it a weak connector. It is easily possible to damage the connector by mis-aligning the digitizer connector

Block Image

Block Image

like this. Check the ends of the connector. The plastic of the connector has been compressed into the connector, causing it to flare out and preventing from making proper contact.

このアンサーは役に立ちましたか？

はい いいえ
スコア 0
コメントを追加

オプション

I ended up fixing this in the end.

All it needed was a couple of minutes in the ultrasonic cleaner and and good brush with IPA.

I'm pretty sure it was the contacts on the board that were the problem.

Thanks for your suggestions

このアンサーは役に立ちましたか？

はい いいえ
スコア 0
コメントを追加
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 151