評価: 13
1
I am having an issue that has now showed up on both iPad Air and iPad Mini.
After digitizer replacement - it seems the magnetic sensor are TOO sensitive. This means that when opening your smartcover - thereby pushing it to the back of the device - it now activates On/Off functionality.
So far I have only seen this with Air and Mini but it's getting more frequent. Any input here is appreciated.
評価: 49
2
Hi Mikkel Rasmussen,
I have finally encountered one of these faults in the wild. My thoughts immediately went to the magnetic wake sensor.
Essentially your intuition is right on the money: replacing the sensor is the solution. Alternatively fitting a complete glass and digitizer assembly that comes with the magnetic wake sensor is what I would advise for those who want a time effective solution. Though replacing the sensor itself is probably the most profitable solution.
I hope this helps :)
このアンサーは役に立ちましたか？
Where is the sensor located?
過去 24時間: 0
過去 7 日: 1
過去 30 日: 3
今までの合計 227
Hi did you end up managing to fix this problem? Im having the same issue :(
Richard Rigava さんによる
Unfortunately I did not fix it with that digitizer. I ordered another digitizer from another company and the issue was gone.
Mikkel Rasmussen さんによる