修理を始めるには コミュニティ ストア

Sony Computer Entertainmentによって製造されたPS4と通称で知られるテレビゲーム用コンソールです。2013年2月20日に製品の発表、2013年11月15日に発売されました。

1698回答 すべてを表示

オプション

What are the measurements of the thermal pads and how many?

I'm looking to change the stock thermal padding for the GDDR5 RAM etc. but I don't know the measurements of each piece or how many individual pads I'll have to cut.

It makes me more comfortable knowing exactly what I'll need. No one has this question's answer on Google so you'll be setting the milestone.

Edit. Are there thermal pads covering things other than the RAM? If so, where, how big and how many? Thanks!

回答がありました！ 回答を表示 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 2
コメントを追加

2件の回答

フィルタ：
参考になった順 新しい順 古い順
ベストアンサー

オプション

These pads are approx. 9mmx9mm you can just make them 10mm x 10mm though since there is plenty of room to make them bigger.

Here are a few pics.

Block Image

Block Image

このアンサーは役に立ちましたか？

はい いいえ
スコア 11

8 件のコメント:

Thanks for the answer! Do you know how many 10x10mm pieces there are? Are there any pieces that are different measurements? If so, how many?

さんによる

There are 8 on the top side and 8 on the bottom side. There are no other thermal pads on this motherboard.

さんによる

I'm looking to do this as well but doesn't the thermal pad need to be the correct thickness ? I'm guessing something like 2 mm would do but I'm not sure.

さんによる

They are 1mm.

さんによる

Thanks for the reply by the way, I just got around to opening up my ps4 and I'm glad I did. Three of the factory thermal pads were hardly even on the memory chip, they were off to the side touching the motherboard like it was slid into place rather than placed down. Also it had way to much thermal compound on the apu. It was a mess.

さんによる

3件以上のコメントを表示

コメントを追加

オプション

Hi Alex

I just teardown my PS4 which is CUH-10XXA on 07/29

Don't know is it too late to share this information with you.

At the beginning I use 2.0mm to replace the thermal pad, and then I turn on my PS4,

but the height is too high so the APU can not touch the heatsink with 3 beep

After that, I use the 0.8mm instead of , so far the machine is ok.

Block Image

このアンサーは役に立ちましたか？

はい いいえ
スコア 1

2 件のコメント:

I am searching through the web, still cannot find any leads for the thickness except for your post. I am changing pads on my PS Pro. Do you think 0.1 cm or 1mm works?

さんによる

.8mm on the side with the APU, as pictured above, .8mm-1mm on the bask side of the board that doesn't have the APU.

さんによる

コメントを追加

回答を追加する

Alex Fung さん、ありがとうございました！
統計データ:

過去 24時間: 5

過去 7 日: 46

過去 30 日: 218

今までの合計 26,076