メインコンテンツにスキップ

iPhoneの5代目となるiPhone 4S。このデバイスの修理は比較的簡単で、スクリュードライバー、開口ツールと忍耐が必要です。GSM/CDMA / 16, 32, 64 GB / 白と黒

2193回答 すべてを表示
締切られた回答

Help Identify These 2 Parts

Hi guys,

I did a screen replacement on a friend's iPhone 4S, and there are 2 small parts left over for which I cannot figure out where they belong.

http://imageshack.com/a/img540/1775/bXrV...

It can't connect to any mobile or wireless network, so that probably has something to do with it but so far I can't spot any such parts in the instructions here.

iPhone 4S スクリーンの交換

It's kinda urgent - I need to return it on Monday. Please help.

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

1 件の回答

最も参考になった回答

The black one (left) goes at the top screw of the battery connector. This piece goes under the battery connector tab, then the top battery screw goes though both. The gold peice (right), goes above the the main camera at the top of the iPhone. It goes on top of the logic board at the left top screw of the logic board. Logic board, then piece with prongs behind (above camera) then the screw goes through it. Then the black tape is applied.

このアンサーは役に立ちましたか?

スコア 4

6 件のコメント:

Hi Brad, thanks alot for your help. I managed to put back the battery connector bit, but still can't figure out the logic board part. Is there a photo around showing this part's installation or could I trouble you to add some arrows to photos please? iFixit is really lacking in the "beware-of-tiny-bits-falling-out" department.

Examples:

https://d3nevzfk7ii3be.cloudfront.net/ig...

https://d3nevzfk7ii3be.cloudfront.net/ig...

さんによる

https://d3nevzfk7ii3be.cloudfront.net/ig...

The order from top to bottom is screw, part, logic board. If you still have the black tape, that goes on top of the screw.

さんによる

https://d3nevzfk7ii3be.cloudfront.net/ig...

shows the orientation of the part to the camera bay, but it goes on top of the logic board at this location. The photo is missing the logic board, which should be under the part here. But it shows how the part should be. Logic board, part on top of logic board, then the screw. Then the black tape.

さんによる

Fantastic crystal clear explanation, Brad. +1 Thank you. However, I'm still not able to get a cell signal, iPhone just keeps saying "searching". Looks like the 2 parts didn't have anything to do with reception. Is this part of a bigger problem and should I start a new question on it or is there something simple that I might have missed putting it back together?

さんによる

Make sure antenna cap on black wire near battery connector is correctly attached. Set time on iPhone correctly. Reset, hold both home and power buttons for about 10 seoconds until iPhone restarts itself. Reset network settings.

さんによる

1以上のコメントを表示

コメントを追加
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 329