メインコンテンツにスキップ

2012年3月16日に発表されたiPadの第3世代モデルです。4GとWi-Fiモデル用の修理ガイドを公開しています。修理には温めて慎重にこじ開ける作業が必須です。

310回答 すべてを表示

Cellular 3g antenna torn

Hi,

I have replaced ipad 3 digitizer successfully, But while removing the cracked one, Top right side piece next to the front camera got torn. without pasting the digitizer i checked following options and all are working.

3g, wifi, Bluetooth,mic sounds, front and rear camera, volume, mute, power, home buttons are fine.

What should i do? do i have to replace the right side part or just leave it as it is and close it back?

I have attached a picture for your reference,

Kindly reply ASAP as I'm wait your respond top proceed to next step.

Thanks & regards

Mevan FErnando

i tired uploading 2 images but it says unknown error

回答がありました! 回答を表示 同じ問題があります

この質問は役に立ちましたか?

スコア 1
1件のコメント

This question was migrated from http://meta.ifixit.com/Answers.

さんによる

コメントを追加

1 件の回答

ベストアンサー

Tearing an antenna usually degrades its RF performance, your cellular reception will still work but with degraded performance, like maybe slower speed, no service in weak coverage areas, higher power consumption.

The right antenna also serves as the proximity sensor, if it is torn, the cellular module will not properly regulate RF transmit power when your hand is touching the area. So the transmit power may be over safety limit(in my opinion not a problem, the whole idea of cellular signal causes cancer is bullsh1t) or constantly latched to low power setting due to the sensor falsely triggering. This can cause performance issues.

So if you think it is a problem, replace it.

このアンサーは役に立ちましたか?

スコア 2
コメントを追加

回答を追加する

Mevan Fernando さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 4

過去 30 日: 21

今までの合計 129