修理を始めるには コミュニティ ストア

2012年9月12日に発表されたApple社による6番目となる iPhone。このデバイスの修理方法は前モデルと類似しており、スクリュードライバーと開封工具が必要です。GSMかCDMA方式、16/32/64 GB。 本体色は黒と白。

2522回答 すべてを表示

オプション

I got the nand error, what precautions should I be taking?

Hello,

I was recently replacing a customers screen when I was faced with the nand error! After much frustration I did some research and disconnected the 3rd flex cable for the proximty sensor and front facing camera. By doing this, the phone successfully booted up. Sequentially I ordered a replacement flex cable, however Im wondering what precautions I should be taking when installing the flex. I usually transfer this flex cable over very carefully from the old screen to the new one, so this error was a surprise to me.

I also noticed that the screen replacement I received has an extremely loose front facing camera bezel, could this have caused and error?

Theres also a black rubber square like (bezel maybe) that comes out from under the flex, where should that be placed?

この質問に回答する 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア -1
1件のコメント

UPDATE:

Just got the replacement part in for the proximity sensor and front facing camera, installation went well and phone booted up properly

さんによる

コメントを追加

3件の回答

フィルタ：
参考になった順 新しい順 古い順
最も参考になった回答

オプション

Seen this before you damaged the ribbon cable removing it - it is very fragile and you most likely caused the damage when removing it from the old screen. You need to heat it to soften the glue and not just pull at it to remove it. Same with the home button - heat up the flex to soften the glue beforehand.

Also most replacement screens dont come with the front camera bezel plastic and it shouldn't be loose - you usually transfer it from the old one and glue it in place on the new one.

このアンサーは役に立ちましたか？

はい いいえ
スコア 2
コメントを追加

オプション

Hi there I have never came across this error but you must have damaged it in someway maybe you tilted the screen to high when taking the emi sheild off and damaged it hard to say

このアンサーは役に立ちましたか？

はい いいえ
スコア 0

2 件のコメント:

No the camera bezal loose would not affect this and the little black peice are you referring to the spacer that is used and has a hole init?

さんによる

Yea thats what Im referring to

さんによる

コメントを追加

オプション

That spacer is just a spacer. Do not screw the long screw in so tight that the retaining plate bends, and then everything should function fine without it.

このアンサーは役に立ちましたか？

はい いいえ
スコア 0
コメントを追加

回答を追加する

iMatt さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 190