メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

iPhoneの5代目となるiPhone 4S。このデバイスの修理は比較的簡単で、スクリュードライバー、開口ツールと忍耐が必要です。GSM/CDMA / 16, 32, 64 GB / 白と黒

3041の回答 すべてを表示

Why is there white spotting going through lcd?

Hello,

I just replaced the front lcd assembly (lcd, digitizer, backlight and frame) and was VERY careful throughout. When pressing the home button and around the home button on the white part of the glass, and pressing towards the upper part of the screen, white spots shine through. They go away when removing finger from screen or holding finger in that position, they will also fade away.

It is for a friend so it is driving me insane!

Hope you can help.

回答がありました! View the answer 同じ問題があります

この質問は役に立ちましたか?

スコア 0

コメント:

Update: when having the back cover removed, the problem is almost next to gone unless I pressed abnormally hard. Back cover must not be a perfect fit and is pressing the backlight against the lcd?

さんによる

コメントを追加

3件の回答

選択されたソリューション

Hello zentech this is caused by the battery been slightly bent and formed a tad out of shape cause when you put the back cover on it puts stress on the lcd underneath

I would take out the battery and also the adesive that held the battery on the frame could be sticking up... Try this and it will 100% work

Take off the adesive on the mid frame that held battery and also the whole plastic pull tab cause you don't need it and straight out battery and make sure nothing is stuck to it..

Do this and problem solved :)

この回答は役に立ちましたか?

スコア 2

コメント:

Great advice as well! Thank you. In the process of putting the phone back together atm. That's funny because the battery did bend a bit on removal, oops! Apple sure makes a tight fitting phone with even a slight component out of place and you get screen issues. Will update with results!

さんによる

No probs lets is no

さんによる

Made a HUGE difference, almost perfect! There's a BIT of space between the the back cover and the iphone framing, almost looks like a half mm bend. I know I had to press the speaker in a bit. Going to tinker around there.

さんによる

I have removed the speaker and there are NO issues. It was not sitting right somehow. Cleaning up the battery fixed some of the spots to begin with as well. Thank you!

さんによる

Glad this helped it's just the battery putting pressure on the lcd

さんによる

コメントを追加

Sounds like a cheap bad screen,, hopefully you can exchange it for a good 1.

この回答は役に立ちましたか?

スコア 0
コメントを追加

The screen is not seated correctly, you may have left on the plastic protector on the back of the screen, also check to make sure you have all the screen screws installed and tight. If you are still having problems you should check the frame it could be bent.

この回答は役に立ちましたか?

スコア 0

コメント:

Thank you, I will reassemble it with your advice.

さんによる

Resolved a small issue with the home button, cut some of the new adhesive I put down around the home button rubber and it now clicks like new! So far no screen issue! (system is barebones atm, battery, board, and lcd)

さんによる

コメントを追加

回答を追加する

zentech さん、ありがとうございました!
統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 133