評価: 71
5
9
I recently installed a motherboard in my 667 Onyx.
When the fan ran on the old board it was loud enough to hear. This one I can't tell if the faint sound is just the HD spin or a quieter fan. Does the fan always run or only when it gets hot enough? I sure would like to not tear the Onyx down again.
評価: 685.3千
3.4千
1.1千
2.6千
You can get this Fan Control software to do the job: http://www.macupdate.com/info.php/id/250...
このアンサーは役に立ちましたか？
+ Ralph
評価: 71
5
9
This a thanx and a comment to Mr. Mayer.
I almost bought the Fan Control software as you suggested. But the price is confusing, $9.99 or 14.99?
Anyway, I took one last shot at activating the fan. I took an 8X10 jpg and Photoshopped the resolution up to 1600 dpi. In less than a minute the fan kicked in with an audible spin.
I am going to download the Fan Control utility.
Thanx again.
Crocdog
このアンサーは役に立ちましたか？
評価: 63
3
6
1
I hope you have luck with the G4FanControl. I used it just fine on a 1.67ghz Alum. PowerBook G4, won't work on any DVI, or ANY Titanium model I know of. I've seen other complaints about Fabrizi's "G4FanControl" not working on Titanium models. For that matter, her official site has complaints, just read ALL the testimonials.
このアンサーは役に立ちましたか？
過去 24時間: 0
過去 7 日: 7
過去 30 日: 8
今までの合計 1,842
