メインコンテンツにスキップ

iPhoneの第4代目で、修理はそのままパーツを直接交換するだけです。しかし、正面ガラスとLCDはセットで交換する必要があります。容量はGSM / 8,、16m32 GB / モデル番号 A1332 /本体カラーは黒と白色

3272の回答 すべて表示

Can the LCD Assembly be compatible with both GSM and CDMA?

I purchased this item without checking whether it was GSM or CDMA:

http://www.ebay.com/itm/400485816225

I asked the seller (who shipped before responding), and he said that it supports both.

What should I do?

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

iPhoneのバッテリーキット

Only $29.99

Buy Now

iPhoneのバッテリーキット

Only $29.99

Buy Now

3回答

最も参考になった回答

I would say because he's a uk seller he's selling a gam model.

Yes CDMA and gsm screens are different the brackets on the screen are in different locations

この回答は役に立ちましたか?

スコア 2

コメント:

So.. what should I do? He refuses to confirm whether it is GSM or CDMA.. and I can't have any more downtime on my iPhone..

による

コメントを追加

You haven't told us what your phone is - GSM or CDMA. They do require different front panels

CDMA iPhones were only released in the USA as far as I can tell so as con says, the parts are likely GSM coming from a UK seller.

iPhone 4 (CDMA/Verizon) Screen

iPhone 4 (GSM/AT&T) Screen

iPhone 4 (GSM/AT&T) Screen画像

製品

iPhone 4 (GSM/AT&T) Screen

$34.99

iPhone 4 (CDMA/Verizon) Screen画像

製品

iPhone 4 (CDMA/Verizon) Screen

$34.99

この回答は役に立ちましたか?

スコア 0

コメント:

It's GSM.

You're right, it's likely they have GSM LCD Assemblies..

But the fact that the guy said that it was the same thing is bothering me, because he was clearly wrong.

による

Woah, wait a second!

95$?! The one I bought on eBay was under 30$!

In fact, 90% of the LCD Assemblies on eBay are under 40$..

What does that mean? Can someone confirm?

による

コメントを追加

I know this is an old question, but yes the LCD and digitizer is exactly the same, the only difference is the bezel, which includes the mounting locations, the CDMA and GSM version have different mounting locations. If this happens to you, using a blow dryer on a lower setting heat up your old screen and the replacement screen around the edges (very carefully you don't want the heat exceeding 200 degrees, I do it with a heat gun and infrared thermometer) try to save the factory glue or tape from replacement or old screen swap the bezel paying attention to the mounting location, heat up a bit and sit it in bezel. I've done it a few times it is not hard.

この回答は役に立ちましたか?

スコア 0
コメントを追加

回答を追加する

Guy Mor さん、ありがとうございました!
統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 1,256