評価: 1
1
2
after i solder iphones power terminal
to the 4 pads who seems intact
iphone does not charge .also keeps
booting ,sometimes does not power on
by sleep/wake botton,how can test
the pads that they are ok,because
they look fine and firmly attached
to logic bord.
regards
評価: 13
2
After a while, the battery in an IDevice runs out of its limited charging cycles
Go to an apple store to replace it
このアンサーは役に立ちましたか？
because battery terminal detacheded from logic board.
when i was removing battery.
i measured pads voltage all of them had
about 4 volts exept 3ed pad from top,if we
count them from top. is it normal?
過去 24時間: 0
過去 7 日: 0
過去 30 日: 0
今までの合計 310
First thing you want to do is to measure the voltage on your freshly soldered contacts. It is possible that they are not making proper contact. Second, why did you need to resolder the contacts what happened to your phone?
oldturkey03 さんによる