メインコンテンツにスキップ

iPhoneの第2世代モデル。モデル番号はA1241 / 8 もしくは16 GBの容量/ ブラックもしくはホワイトのプラスチック製背面ケース。修理はオリジナルiPhoneに比べて直接パーツに作業ができます。ドライバー、こじ開けるためのツールと吸盤カップが必要です。

1505の回答 すべて表示

dropped in water. Black screen except in sunlite. touch screen works

I dropped my Iphone in water, only a few seconds. Powered it off and placed in a bag of rice for three days. After three days, I charged the phone and when I powered it on, I could hear sounds and feel it vibrating. In sunlight I can faintly see the touch screen. I was able to put in my pass-code and retrieve instant message and work other apps. What can I do to get the screen back to normal?

回答がありました! View the answer 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

iPhoneのバッテリーキット

Only $29.99

Buy Now

iPhoneのバッテリーキット

Only $29.99

Buy Now

3回答

選択されたソリューション

sherribalmer , the first thing that I would suggest is that you follow this guide. It was written for the 3G. Once you got it accomplished, re-evaluate the damage and do replace the battery. It will also prevent corrosion down the line. If you do not clean your phone now, you may end up with damage in a couple of weeks. Anyhow, once you did that see what happens. Since your screen remains black, my gut feeling would be that it is short circuited. You will most likely have to replace it. Not a terrible job to do and not really to expensive. Here is the how-to and the part is available at available at multiple places. I prefer the whole assembly since it causes a whole lot less headache and is far more convenient. If a new LCD should not work, you must remember that your phone also uses a backlight coil and backlight IC that may have shortened out. The coil can be replaced, but does require soldering on the logic board, whereas the IC requires a reballing. Hope this helps, good luck.

iPhone 3GS Display Assembly画像

ガイド

iPhone 3GS Display Assembly Replacement

難易度:

普通

15 minutes

iPhone画像

ガイド

iPhoneの水濡れ・水没ダメージからの復旧方法

難易度:

難しい

1 - 2 hours

この回答は役に立ちましたか?

スコア 1
コメントを追加

The LCD display is bad, you will either need to buy a replacement LCD and Digitizer or just an LCD. Personally I recommend the LCD and Digitizer simple replacement and no heatgun needed :)

この回答は役に立ちましたか?

スコア 0
コメントを追加

the backlight of LCD is damaged while display function is ok...so you have to replace a LCD

この回答は役に立ちましたか?

スコア 0
コメントを追加

回答を追加する

sherribalmer さん、ありがとうございました!
統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 2,934