I just built an AMD Ryzen 7-5600x. Hopefully, that will run W11, but all my other computers are i7 and one i5 so those will stay on W10 until they die. But regressing to W8 is definitely not advised. That OS is worse than Vista IMHO. Neither of which I ever used.
My sister’s GE had an identical problem. Technician replaced a control board. Though it was in need of new capacitors, it was not the cause of the problem. The typical cause of this problem is a bad freezer seal. After careful inspection of the seal, I could not see any leaks. I then removed the seal and as I closed the freezer door I sensed that something was keeping it from closing completely. I found that to be the lower drawer. For some reason it was sticking out just a little too far and it was not because something was holding it from completely retracting. I pulled the front plastic façade off and the door shut completely. I replaced the seal and everything was fine — until it developed another problem. She got rid if it. A friend called me for an identical problem. I told him to check that the door was closing. He said it did. When I went over to see, it was not because a drawer was not fully retracting because it has come off the slides. After repositioning the drawer to retract, everything was fine.
3D printing is definitely not plug and play. The main factors of a successful print are: (1) Proper bed. Type of bed and adhesion “glue”. This might be a PEI bed, which means a proper cleaning and bed temperature for the material used. Or it might be painters tape or hair spray on a glass bed. (2) First layer height. This is a combination of slicer first layer height configuration and nozzle distance to bed after a Z homing, controlled by the Z endstop. (3) Temp of hotend. This depends on material used, speed of printing and size of print. (4) Speed of print. This is limited by the printer mechanics, and should be set based on: ## The quality of print desired = slower for fine detail (1) The size of the print = faster for large prints with less detail. (2) Layer height. Smaller for fine detail, (3) Nozzle diameter. Larger for large layer heights. Most prints can be accomplished with a 0.4mm nozzle. I also like 0.3mm especially for finer detail and smaller layer heights. (4) A level bed. This will cause a...
Normally, most TVs will power up after a few seconds of turning on power to allow the PSU to stabilize. When the relays activate, if there is a problem with other powered circuitry, as in an abnormal load, it will then shut down and start the power cycle again. Disconnecting a cable would point to the board that has a problem. However, if that board is connected to another circuit the problem might be in that circuit. This follows Brandon’s find of burned resistors off the main board. Replacing the resistors will not solve the problem until the cause of the burn is found. A schematic will tell you what the resistors power, and of course, if the resistors are burned only a schematic will tell you what the value is. Otherwise, it is replacing parts till you get results, which can become more costly the a new TV.