Hi Jackie, From what you describe it looks like you have a selector issue. When changing gear a different selector leaver lifts the gears into the right position for the clutch to reengage the drive. depending on the auto box is could be oil pressure that makes the selection If you have been getting this issue between two gears then that will be the selector or pick up that has an issue, extreme temperature changes can also effect selectors when transition oil is low or old. The display uses a passive switch usually a simply magnet normally on the leaver to the gear box being that the issues should be with the gear selector the display would still operate correctly. I would visit a good mechanic and say that you have a selector issue between the gears and see what the offer, with the miles you have on this car they may only offer a replacement transition.
Ok i’m not an expert but the only radiation from a phone would be RF? Electrons are Beta but you wouldn’t be losing them unless you where burning the battery out from 100% to 0% in seconds the only other radiation from LED would be light while some believe this can be an issue i do think its still up for debate.
Most of these are just a stronger nail varnish remover solution, in some cases they are just average everyday nail varnish remover rebranded lol. however a common makeup of the chemicals shown below. Proprietary: No Ingredient: Odorless Mineral Spirits [Naphtha , (petroleum), hydro-treated, heavy] Ingredient Sequence Number: 01 Percent: 99.9% CAS Number: 64742-48-9 Proprietary: No Ingredient: D & C Red #17 Ingredient Sequence Number: 02 Percent: <0.1% Proprietary: Yes Ingredient: Many Flowers Fragrance Ingredient Sequence Number: 03 Percent: <0.1%
Has anything been replaced or repaired on the device? also you can still get it into recovery regardless of how long its on for, just hold the volume down and power button until you see the iTunes logo. You can try disconnecting the front camera flex and booting the device this could yield a better result.