I broke the screen on opening for 2 reasons. First. Should be clearly notated that the ribbon cable between the OLED and the DIGITIZER (which SHOULD COME OFF IN ONE PIECE WHEN YOU REMOVE THE DISPLAY) sits INTO the bottom right side of the glass bezel. So the instructions to “not go further than the colored (white or black) glass into where the display is”, is inaccurate.
Second, my digitizer separated from the OLED while lifting it out, was this because the adhesive wasn’t hot enough? How to avoid this??
Yes, me too. I’d like advice as to how to vary the glue heating process for this to not occur. Does the heat need to be applied for longer so the deeper OLED panel releases without pulling from the glass?
And another note - I used the suction cup to lift the glass. Unfortunately the glass cracked at that point…bummer. I would update this to describe HOW to lift the glass. As in, LIGHTLY lift up with the suction cup while mostly lifting up on the guitar picks to help separate..
Agreed. I just removed the glass from the OLED display…oopss. I’m hosed.