メインコンテンツにスキップ

この分解で使用される工具

この分解は修理ガイドでは ありません。 お持ちのWireless Bluetooth Water Dancing Speakers (SBT626) from Sharper Imageを修理する際は、iFixitの修理ガイドをご利用ください。

  1. Teardown of Water Dancing Speaker
    • Teardown of Water Dancing Speaker

  2. Remove 4 screws from rear of speaker Peel back the rear half of the shell Remove the Water/Pump Chamber
    • Remove 4 screws from rear of speaker

    • Peel back the rear half of the shell

    • Remove the Water/Pump Chamber

  3. Remove 2 screws that hold the logic circuit in place Carefully pull the logic board up,  out of the plastic slot Carefully pull the logic board up,  out of the plastic slot
    • Remove 2 screws that hold the logic circuit in place

    • Carefully pull the logic board up, out of the plastic slot

  4. Android 修理キット

    交換用スクリーンやバッテリーの修理キット

    ショップを見る

    Android 修理キット

    交換用スクリーンやバッテリーの修理キット

    ショップを見る
  5. Carefully pull the Lithium Ion Battery out of the plastic slot If glue is holding battery in place, slowly peel the glue off the battery.
    • Carefully pull the Lithium Ion Battery out of the plastic slot

    • If glue is holding battery in place, slowly peel the glue off the battery.

  6. Remove the 3 screws holding the speaker Remove the speaker from the plastic shell
    • Remove the 3 screws holding the speaker

    • Remove the speaker from the plastic shell

  7. Disconnect the battery connector from the logic board Disconnect the motor connector from the logic board
    • Disconnect the battery connector from the logic board

    • Disconnect the motor connector from the logic board

  8. Disconnect the speaker connector from the logic board Disconnect the LED connector from the logic board
    • Disconnect the speaker connector from the logic board

    • Disconnect the LED connector from the logic board

  9. Remove the 2 screws holding the motor mount on the water/pump chamber Remove the motor mount from the water/pump chamber Remove the 2 screws holding the LED board on the water/pump.
    • Remove the 2 screws holding the motor mount on the water/pump chamber

    • Remove the motor mount from the water/pump chamber

    • Remove the 2 screws holding the LED board on the water/pump.

    • Remove the LED board from the water/pump

  10. Teardown Finished
    • Teardown Finished

    • For Reassembly: Follow Guide in Reverse

Kyle Trambley

メンバー登録日: 2016年10月06日

284 ポイント

1ガイドが承認済み

チーム

Cal Poly, Team 15-7, Livingston Fall 2016 Cal Poly, Team 15-7, Livingston Fall 2016人のメンバー

CPSU-LIVINGSTON-F16S15G7

4 メンバー

6のガイドは作成済み

0 件のコメント

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 9

過去 30 日: 48

今までの合計 488