はじめに

This is a basic teardown of the venerable TI-82 calculator.

この分解は修理ガイドでは ありません。 お持ちのTexas Instruments TI-82を修理する際は、iFixitの修理ガイドをご利用ください。

The calculator comes with a matching protective shield which slides down over the front; when the calculator is in use, you can slide it over the back.  This is a nice touch, as it makes the cover much more difficult to lose.
  • The calculator comes with a matching protective shield which slides down over the front; when the calculator is in use, you can slide it over the back. This is a nice touch, as it makes the cover much more difficult to lose.

コメントを追加する

Flip the device over to access the battery cover. Using a spudger, pry the release tab down and then pull the battery door up and off the calculator. Remove:
  • Flip the device over to access the battery cover.

  • Using a spudger, pry the release tab down and then pull the battery door up and off the calculator.

  • Remove:

    • 2 7.2mm Phillips #0 screws

    • 1 15.3mm Phillips #0 screw, and a battery retaining clip.

  • The CR1616 coin cell battery preserves settings and programs in memory while the main batteries are being changed.

コメントを追加する

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Insert a spudger into the seam between the two halves of the case, and pry it apart.
  • Insert a spudger into the seam between the two halves of the case, and pry it apart.

  • Watch out for corrosion in older calculators around the battery terminals -- this is why you should never leave batteries in electronics for extended periods of time.

コメントを追加する

Opening the two halves of the calculator reveals a foil shield over the rest of the electronics.
  • Opening the two halves of the calculator reveals a foil shield over the rest of the electronics.

  • Remove four Phillips screws to access the electronics underneath, then pull the shield away.

コメントを追加する

... And, here's the guts of the thing.
  • ... And, here's the guts of the thing.

    • SRM20255LLM10 / F4ZM1938 (32Kbyte SRAM)

    • LH531GP4 (Mask ROM)

    • T 84C00AM-8 (Z80 CPU)

    • Toshiba / TC14L010AF / 1273 9506EAI (ASIC)

コメントを追加する

Remove the remaining Phillips screws. The screen and main board will lift out, leaving the membrane keypad in the front case.
  • Remove the remaining Phillips screws.

  • The screen and main board will lift out, leaving the membrane keypad in the front case.

コメントを追加する

bushing

メンバー登録日: 2010年04月23日

9,026 ポイント

17のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 8

過去 30 日: 75

今までの合計 14,643