Skip to main content

はじめに

For our reverse engineering project, we chose to use the smoke detector. This smoke detector consists of a sensor to detect smoke and a loud electronic buzzer to alert people within the building.

この分解は修理ガイドでは ありません。 お持ちのGas and Smoke Detectorを修理する際は、iFixitの修理ガイドをご利用ください。

  1. Use a screwdriver to pry open the plastic enclosure. It might be easier to push the buzzer through the hole, if you need extra leverage. Use a screwdriver to pry open the plastic enclosure. It might be easier to push the buzzer through the hole, if you need extra leverage.
    • Use a screwdriver to pry open the plastic enclosure. It might be easier to push the buzzer through the hole, if you need extra leverage.

  2. The buzzer is unhooked from the PCB board, by hands.
    • The buzzer is unhooked from the PCB board, by hands.

  3. MacBook Battery 修理キット

    最低価格 $69.99

    Buy Now

    MacBook Battery 修理キット

    最低価格 $69.99

    Buy Now
  4. This is the circuit for the smoke detector. It is powered by a 9V battery. The 3 metal leafs are contacts for the buzzer and the bigger leaf is for the test button. This is the circuit for the smoke detector. It is powered by a 9V battery. The 3 metal leafs are contacts for the buzzer and the bigger leaf is for the test button.
    • This is the circuit for the smoke detector. It is powered by a 9V battery. The 3 metal leafs are contacts for the buzzer and the bigger leaf is for the test button.

  5. The metal cap is removed to reveal a, MC145017, driver chip and americium sensor. Do not remove americium from the sensor!
    • The metal cap is removed to reveal a, MC145017, driver chip and americium sensor. Do not remove americium from the sensor!

Ari Dubinsky

メンバー登録日: 2014年03月04日

253 ポイント

1ガイドが承認済み

コメントを追加する

統計データを表示:

過去 24時間: 2

過去 7 日: 17

過去 30 日: 86

今までの合計 4,841