メインコンテンツにスキップ

修理を始めるには

修理する権利

ストア

はじめに

Teardown of the Sky TV Remote, note: not Sky+ or Sky HD.

この分解は修理ガイドでは ありません。 お持ちのSky TV Remoteを修理する際は、iFixitの修理ガイドをご利用ください。

  1. This is it. Well, this is it in a functional state. Remove the batteries before starting! Remove the batteries before starting!
    • This is it. Well, this is it in a functional state.

    • Remove the batteries before starting!

  2. Use a Philips head screwdriver to remove this screw Use a spudger to unlock all the tabs around the sides, start at the bottom Work your way all the way around the remote, this is flippin' tricky.
    • Use a Philips head screwdriver to remove this screw

    • Use a spudger to unlock all the tabs around the sides, start at the bottom

    • Work your way all the way around the remote, this is flippin' tricky.

    • Brute force is compulsory.

  3. After all the tabs are off, the body should just fall away leaving the buttons, the circuit board, the case and the black infra-red bit at the end. Ta-daa! Ta-daa!
    • After all the tabs are off, the body should just fall away leaving the buttons, the circuit board, the case and the black infra-red bit at the end.

    • Ta-daa!

QEIIRepair

66 ポイント

1ガイドが承認済み

コメント1件

On early models theres a second screw under the black infa red filter. If it doesnt come apart as above, ther black filter is held on by two tabs. On the battery compartment side, the black plastic nearest the battery, wedge a small screwdriver between the body and the pastic and the filter should slide away revealing a second screw!

tim - 返信

コメントを追加

統計データを表示:

過去 24時間: 1

過去 7 日: 11

過去 30 日: 58

今までの合計 14,507