メインコンテンツにスキップ

はじめに

This is a Sega Genesis model 2. In this tear down you will be able to see what the inside of the Sega Genesis should look like.

この分解は修理ガイドでは ありません。 お持ちのSega Genesis IIを修理する際は、iFixitの修理ガイドをご利用ください。

  1. Flip the system over
    • Flip the system over

  2. Remove the four outer screws (you may want a small cup to keep your screws in.) Remove the four outer screws (you may want a small cup to keep your screws in.)
    • Remove the four outer screws (you may want a small cup to keep your screws in.)

  3. Take plastic top off.
    • Take plastic top off.

  4. Remove the nine inner screws.
    • Remove the nine inner screws.

  5. Remove metal piece.
    • Remove metal piece.

  6. You now have access to your circuit board. (If you wish to remove the circuit board, continue.)
    • You now have access to your circuit board. (If you wish to remove the circuit board, continue.)

  7. Remove the two screws highlighted in picture to remove the circuit board.
    • Remove the two screws highlighted in picture to remove the circuit board.

  8. Lift the black piece of plactic up.
    • Lift the black piece of plactic up.

  9. Lift up the metal piece.
    • Lift up the metal piece.

  10. You now have access to the inside of the bottom plastic piece.
    • You now have access to the inside of the bottom plastic piece.

  11. This is the circuit board. This is the circuit board. This is the circuit board.
    • This is the circuit board.

  12. Do the steps backwards to reassemble.
    • Do the steps backwards to reassemble.

Thor Odinson

メンバー登録日: 2015年06月04日

152 ポイント

1ガイドが承認済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 4

過去 30 日: 44

今までの合計 4,870