はじめに

This guide provides step-by-step instructions on disassembling the Picstart Plus development programmer.

この分解は修理ガイドでは ありません。 お持ちのPicstart Plus Development Programmerを修理する際は、iFixitの修理ガイドをご利用ください。

Remove 4 Phillips screws located on the back side of the holding plate. After the screws are removed, remove the case of the development programmer. Carefully take out the circuit board with component side facing up. Put the case aside.
  • Remove 4 Phillips screws located on the back side of the holding plate.

  • After the screws are removed, remove the case of the development programmer.

  • Carefully take out the circuit board with component side facing up. Put the case aside.

コメントを追加する

Disconnect the microcontroller module from the main board using a spudger or a similar tool. Set the microcontroller module aside.
  • Disconnect the microcontroller module from the main board using a spudger or a similar tool.

  • Set the microcontroller module aside.

コメントを追加する

Flip over the mainboard so that the component side is facing down and remove the small Pan head screws that holds the cover of the IC holder Remove the cover of the IC holder.
  • Flip over the mainboard so that the component side is facing down and remove the small Pan head screws that holds the cover of the IC holder

  • Remove the cover of the IC holder.

コメントを追加する

Remove the IC holder lever along with the small metal plate that covers the lever. Set the lever and the lever cover aside.
  • Remove the IC holder lever along with the small metal plate that covers the lever.

  • Set the lever and the lever cover aside.

コメントを追加する

Congratulations! You have completely dismantled the PICSTART Plus Development Programmer!
  • Congratulations! You have completely dismantled the PICSTART Plus Development Programmer!

  • All the extracted components are shown in the picture.

コメントを追加する

Brad

メンバー登録日: 2013年11月17日

624 ポイント

2のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 21

今までの合計 1,389